RC Slope Soaring in Hong Kong :: View topic - PC9 同 Mustang 合新手玩嗎?

RC Slope Soaring in Hong Kong http://www.rcsail.com/forum/

PC9 同 Mustang 合新手玩嗎? http://www.rcsail.com/forum/viewtopic.php?f=3&t=1072	Page 1 of 1

Author:	TLK [ Wed Aug 01, 2007 12:48 pm ]
Post subject:	PC9 同 Mustang 合新手玩嗎?
http://www.canterburysailplanes.co.nz/i ... m/PC9.html http://www.canterburysailplanes.co.nz/i ... stang.html 小弟係超級新手.唔知PC9 同 Mustang 合新手玩嗎? 這2架機可以邊到買到? 幾$左右??? 新手玩問題大嗎? 2架邊架比較好. 謝謝師兄

Author:	ming yyy [ Wed Aug 01, 2007 9:55 pm ]
Post subject:
兩個都合新手玩,但Eraser較佳,全部德昌可買到,大約$630,Good fun!

Author:	TLK [ Fri Aug 03, 2007 9:36 pm ]
Post subject:
睇左幾日都係比較喜歡Multiplex Easy Glider http://www.modelspot.com/mpx/easyglider.htm 這隻是否識合新手? 使唔使比較大風先玩到? 德昌能買到嗎? 價$大約幾多? THX各位師兄

Author:	CM Cheng [ Fri Aug 10, 2007 8:53 pm ]
Post subject:
Hi TLK, 我有同事用 Canterbury 的 PC9 和 Split Fire(=Mustang) 來學飛，我兩隻都借來飛過，感覺差不多，呢D機本身設計係做動作，反應算快同好靈活，雖然唔及"傳統學飛"要求慢及定，但我覺得用來學飛都OK，特別係EPP材料撞唔爛及安全。 Canterbury D 機要落刀切，工序稍多，但都算易砌。 Easy Glider 係 Multiplex 出品，質量一定好，佢材料叫Elapor，介乎PS發泡膠與EPP之間，好耐用(但不及EPP)，我自己都有隻 Multiplex 的 Elapor 機，全部零件都係 mold 出來，非常準確同易砌，一定成功！ Easy Glider 我未飛過，但睇設計應很適合用來學飛，Easy 比 PC9 同 Mustang 更適合飛細風，也可參考台灣朋友對它的評價: http://www.efly98.com/cdb_efly98/viewthread.php?tid=39492&fpage=1&highlight=%AEe%A9%F6%B7%C6 http://www.efly98.com/cdb_efly98/viewthread.php?tid=39586&fpage=1&highlight=%AEe%A9%F6%B7%C6 德昌係Multiplex代理

Author:	joe1130 [ Sat Aug 11, 2007 5:01 pm ]
Post subject:	你可以買架U2 快又得慢又得

Author:	TLK [ Mon Aug 20, 2007 6:57 pm ]
Post subject:
前10日買架F20.小弟係第一次玩Glider.返到屋企好開心係咁整.但整左2日整到七七八八到整servo既時候發現D位係極道唔合.....要左「界界」右「界界」整左半日D位合啦入servo set機啦但唔知點解D servo 係咁打冷震.......真係有D灰心呀>.<..... 有無師兄可以解答我點解servo會係咁打冷震? 點先可以解決@@?

Author:	Stanley [ Mon Aug 20, 2007 7:19 pm ]
Post subject:
TLK wrote: 前10日買架F20.小弟係第一次玩Glider.返到屋企好開心係咁整.但整左2日整到七七八八到整servo既時候發現D位係極道唔合.....要左「界界」右「界界」整左半日D位合啦入servo set機啦但唔知點解D servo 係咁打冷震.......真係有D灰心呀>.<..... 有無師兄可以解答我點解servo會係咁打冷震? 點先可以解決@@? 打冷震係有好多原因。你推個控的推桿有沒有反應？如果有反應，即係話接收ok，如果唔係，你個控可能同個接收唔夾，pcm控fm接收的話D servo就會打冷震。如果控有反應servo會育但打冷震，咁就可能D servo有問題。

Author:	TLK [ Mon Aug 20, 2007 8:16 pm ]
Post subject:
個接收係之前用開的.之前用於三角機完全無問題. 現在反應有DD..唔太大....主要係servo 左右左右係咁打冷震.......

Author:	Stanley [ Mon Aug 20, 2007 10:27 pm ]
Post subject:
TLK wrote: 個接收係之前用開的.之前用於三角機完全無問題. 現在反應有DD..唔太大....主要係servo 左右左右係咁打冷震....... 比多少少資訊至可以了解問題出處架！你插

Author:	Steven Kwok [ Mon Aug 20, 2007 10:37 pm ]
Post subject:
check to see if the receiver battery is fully charged

Author:	TLK [ Tue Aug 21, 2007 11:58 am ]
Post subject:
我用2隻s3003 1.2V電x4 『電池箱』我set機個時係用Am既MJ槍控 . 『D行程 .反應完全無問題』 .但一轉返用JR9X 控同接收之後 2個Sevro就係咁震 .但有小小反應...但反應極慢......

Author:	CM Cheng [ Tue Aug 21, 2007 12:13 pm ]
Post subject:
9X is FM, and your receiver is AM!!! That's why they are not compatible. Hi TLK, do you know that there are AM, FM-PPM , FM-PCM and the latest 2.4G SST radio system in the market? Stanley has an excellent tutorial on the RC sailplane and radio. Maybe you'd better refer to it first http://www.rcsail.com/helpfiles.htm#RC%20equipment

Author:	TLK [ Tue Aug 21, 2007 12:47 pm ]
Post subject:
我係用個FM接收的之前用開的.完全無問題.但現在唔知點解出左問題

Author:	CM Cheng [ Tue Aug 21, 2007 1:07 pm ]
Post subject:
Your 9X can be switched between PPM and PCM. From you description I think your receiver is a FM (PPM) and your 9X is set to PCM.

Author:	TLK [ Tue Aug 21, 2007 5:44 pm ]
Post subject:
謝謝師兄問題已經解决..原來真係未Set PPM thx

Page 1 of 1	All times are UTC + 8 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/