| RC Slope Soaring in Hong Kong http://www.rcsail.com/forum/ |
|
| Making Mini NYX canopy without mold http://www.rcsail.com/forum/viewtopic.php?f=3&t=422 |
Page 1 of 1 |
| Author: | Ah Pong [ Fri Feb 25, 2005 11:46 pm ] |
| Post subject: | Making Mini NYX canopy without mold |
|
|
|
| Author: | Ah Pong [ Fri Feb 25, 2005 11:52 pm ] |
| Post subject: | |
 hardly see any difference!
|
|
| Author: | CM Cheng [ Fri Feb 25, 2005 11:55 pm ] |
| Post subject: | |
Your canopy is too beautiful to put on your ugly damaged MiniNyx 
|
|
| Author: | wai3330 [ Sun Feb 27, 2005 11:43 pm ] |
| Post subject: | |
Hi, Ah Pong! May I know how to make this beautiful canopy? Thanks! |
|
| Author: | mini_trooper [ Wed Mar 09, 2005 5:18 pm ] |
| Post subject: | |
阿邦哥哥, 請問你呢個罩 |
|
| Author: | Ah Pong [ Wed Mar 09, 2005 7:23 pm ] |
| Post subject: | |
Dear friends, Sorry for the late reply as I am very busy in clearing the overdue works after my vacation. I have not taken any photo when making these canopies. I will take photo next time. In brief, I used two layers of shinking tube for sandwiching two layers of CF (my stock of CF is a bit thin, and of course, you should put PVA around the shinking tubes). The mold was the fuse itself, just used the other side of the cone. Regards, |
|
| Page 1 of 1 | All times are UTC + 8 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|