| RC Slope Soaring in Hong Kong http://www.rcsail.com/forum/ |
|
| 省電夜航裝置DIY http://www.rcsail.com/forum/viewtopic.php?f=3&t=189 |
Page 1 of 1 |
| Author: | Billy [ Fri Jul 09, 2004 3:09 am ] |
| Post subject: | 省電夜航裝置DIY |
有興趣裝燈夜航可到此處睇下 http://et.efly98.com/pro03.htm |
|
| Author: | m_c [ Sat Jul 10, 2004 11:45 am ] |
| Post subject: | Re: 省電夜航裝置DIY |
站內的鋰電充電器斗設計有問題。會充爆電。 |
|
| Author: | Kevin YSL [ Sat Jul 10, 2004 4:19 pm ] |
| Post subject: | |
呀 m_c 兄原因何在!? |
|
| Author: | m_c [ Sat Jul 10, 2004 4:56 pm ] |
| Post subject: | 原因 |
叉鋰電, 叉機要有恆流及可以測量當時電壓再作出反應,而再改變恆流。否則鋰電內的鋰化合物會氣化, 其後彭脹而爆炸。 |
|
| Author: | M_C [ Sat Jul 10, 2004 5:08 pm ] |
| Post subject: | Re: 省電夜航裝置DIY |
叉鋰電,叉機要有恆流及能夠測量當時的電壓而再改變恆流,否則鋰電內的鋰化合物會氣化,其後彭脹爆炸。 |
|
| Author: | M_C [ Sat Jul 10, 2004 5:10 pm ] |
| Post subject: | 原因 |
叉鋰電,叉機要有恆流及能夠測量當時的電壓而再改變恆流,否則鋰電內的鋰化合物會氣化,其後彭脹爆炸。 |
|
| Author: | MC [ Sat Jul 10, 2004 5:12 pm ] |
| Post subject: | 原因 |
叉鋰電,叉機要有恆流及能夠測量當時的電壓而再改變恆流,否則鋰電內的鋰化合物會氣化,其後彭脹爆炸。 |
|
| Author: | M_C [ Sat Jul 10, 2004 5:18 pm ] |
| Post subject: | |
小BatBat,Swing是甚麼? |
|
| Author: | CM Cheng [ Sat Jul 10, 2004 5:41 pm ] |
| Post subject: | |
According to the original document and circuit, it does take the 'constant current - constant voltage' charging phases of Lithium batteries into account. Q1 and R1 are added to the voltage regulator for current limiting. However, with the inherent dangerous of lithium batteries, I agree that people who would like to try this circuit should take full precaution. |
|
| Author: | Kevin YSL [ Sat Jul 10, 2004 6:51 pm ] |
| Post subject: | |
OIC! m_c Bat(子明出品) & Swing(京商) 均為滑翔機名稱!! |
|
| Author: | M_C [ Sun Jul 11, 2004 4:26 pm ] |
| Post subject: | |
明白。 thank! |
|
| Author: | m_c [ Wed Jul 14, 2004 12:06 am ] |
| Post subject: | t4vf改5ch有問題 |
久電容一粒,否則輸出脈波不能固定。可能某伺服馬達不能使用。 可上yyksuper.com參考。 |
|
| Page 1 of 1 | All times are UTC + 8 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|