Hong Kong RC Sailplane Forum 香港滑翔機發燒友論壇
http://www.rcsail.com/forum/

RDS FR3
http://www.rcsail.com/forum/viewtopic.php?f=15&t=1871
Page 1 of 1

Author:  K.Y.Mak [ 16 Sep 2010 01:34 am ]
Post subject:  RDS FR3

This is a very well made plane.

There are not much left for the builder to do.

That is Very good 8)

Image

Waiting for tail servos to be drop in
Image

Nicely finished tail parts
Image

Smooth wings
Image

Just have to drop in the servos and tight up the screws
Image

Came with all the required parts
Image

Author:  K.Y.Mak [ 18 Sep 2010 03:32 pm ]
Post subject: 

Set all servos to central position. Drop in to servo tray and tighten up the screws:
Image

stick the 6pin plug with double sided tape on to a block of wood
Image

epoxy the 6 pin plug onto the wing @ 90 degree angle.
Image

Author:  K.Y.Mak [ 18 Sep 2010 03:41 pm ]
Post subject: 

Add wood to reinforce the servo mount @ below
Image

Mount the tail servos
Image

wrap the carbon rods with fiber + AA
Image

Remove anything that's not required for F3F
Image

Author:  K.Y.Mak [ 18 Sep 2010 03:49 pm ]
Post subject: 

Installation completed with nose weight added
Image

Add a dent to the tail as a personalize feature :shock: :roll:
Image

The charming lady on TV said : She is a beauty :!: :!: :o
Image

Image

Author:  CM Cheng [ 19 Sep 2010 08:56 pm ]
Post subject: 

阿麥,你一向都坐係地下砌機?

Image

Author:  K.Y.Mak [ 19 Sep 2010 09:05 pm ]
Post subject: 

CM Cheng wrote:
阿麥,你一向都坐係地下砌機?


Sure ! !

It's my largest work bench 8)
Did you notice how I mix epoxy on the floor?

Just have to remind yourself not to step on the epoxy or the wings :lol:

Page 1 of 1 All times are UTC + 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/