RC Slope Soaring in Hong Kong http://www.rcsail.com/forum/ |
|
RDS FR3 http://www.rcsail.com/forum/viewtopic.php?f=15&t=1871 |
Page 1 of 1 |
Author: | K.Y.Mak [ Thu Sep 16, 2010 1:34 am ] |
Post subject: | RDS FR3 |
This is a very well made plane. There are not much left for the builder to do. That is Very good Waiting for tail servos to be drop in Nicely finished tail parts Smooth wings Just have to drop in the servos and tight up the screws Came with all the required parts |
Author: | K.Y.Mak [ Sat Sep 18, 2010 3:32 pm ] |
Post subject: | |
Set all servos to central position. Drop in to servo tray and tighten up the screws: stick the 6pin plug with double sided tape on to a block of wood epoxy the 6 pin plug onto the wing @ 90 degree angle. |
Author: | K.Y.Mak [ Sat Sep 18, 2010 3:41 pm ] |
Post subject: | |
Add wood to reinforce the servo mount @ below Mount the tail servos wrap the carbon rods with fiber + AA Remove anything that's not required for F3F |
Author: | K.Y.Mak [ Sat Sep 18, 2010 3:49 pm ] |
Post subject: | |
Installation completed with nose weight added Add a dent to the tail as a personalize feature The charming lady on TV said : She is a beauty |
Author: | CM Cheng [ Sun Sep 19, 2010 8:56 pm ] |
Post subject: | |
阿麥,你一向都坐係地下砌機? |
Author: | K.Y.Mak [ Sun Sep 19, 2010 9:05 pm ] |
Post subject: | |
CM Cheng wrote: 阿麥,你一向都坐係地下砌機?
Sure ! ! It's my largest work bench Did you notice how I mix epoxy on the floor? Just have to remind yourself not to step on the epoxy or the wings |
Page 1 of 1 | All times are UTC + 8 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |