Stanley,
We spoke about the subject. I could able to build the hardware stuff.
Could you make the eletronic stuff ??
A web page worth to read as reference:
http://www.8linx.com/cnc/electronics.htm
| RC Slope Soaring in Hong Kong http://www.rcsail.com/forum/ |
|
| DIY CNC foam cutting http://www.rcsail.com/forum/viewtopic.php?f=15&t=1596 |
Page 1 of 1 |
| Author: | Ah Pong [ Sun Apr 12, 2009 8:20 pm ] |
| Post subject: | DIY CNC foam cutting |
Stanley, We spoke about the subject. I could able to build the hardware stuff. Could you make the eletronic stuff ?? A web page worth to read as reference: http://www.8linx.com/cnc/electronics.htm
|
|
| Page 1 of 1 | All times are UTC + 8 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|