RC Slope Soaring in Hong Kong http://www.rcsail.com/forum/ |
|
Race-M & Aris repair http://www.rcsail.com/forum/viewtopic.php?f=12&t=1676 |
Page 1 of 1 |
Author: | K.Y.Mak [ Mon Oct 12, 2009 12:27 pm ] |
Post subject: | Race-M & Aris repair |
星期日在 MOS 比賽時,才發現隻 Aris 有條定位pin 不見了 有誰可幫忙找到? 是鋁的6mm圓柱體 前晚修補隻 Race-M 出賽 MOS, 因太心急,近尾部推竿位的修補材料與推竿出現摩擦現像! 正在想辦法中 我兩隻主戰機都同時有故障、慘 |
Author: | Ah Pong [ Mon Oct 12, 2009 1:08 pm ] |
Post subject: | |
Ah Mak, I have 6mm steel that fit for the alignment pin. Tell me how long, and I can cut for you. Do you have photo of the RaceM? May be I can tell you how to fix it. BR, Pong |
Author: | K.Y.Mak [ Mon Oct 12, 2009 3:16 pm ] |
Post subject: | |
Ah Pong wrote: Ah Mak,
I have 6mm steel that fit for the alignment pin. Tell me how long, and I can cut for you. Do you have photo of the RaceM? May be I can tell you how to fix it. BR, Pong Hi Ah Pong, I think it's around 20mm long. However, Steel is very hard ! Do you have the tool to make a rounded head on one end for easy insertion? How about carbon rod ? |
Author: | Ah Pong [ Mon Oct 12, 2009 7:53 pm ] |
Post subject: | |
The bad thing for using CF rod is, when it breaks, it would be so difficult to take the residual away. |
Author: | CM Cheng [ Mon Oct 12, 2009 8:25 pm ] |
Post subject: | |
唔好攪,攪咗冇冠軍 但如果冇冠軍都OK,我可以幫你車一條,你要 6061、7075 定五金鋪 cheap cheap 鋁 |
Author: | K.Y.Mak [ Mon Oct 12, 2009 9:42 pm ] |
Post subject: | |
CM Cheng wrote: 唔好攪,攪咗冇冠軍
但如果冇冠軍都OK,我可以幫你車一條,你要 6061、7075 定五金鋪 cheap cheap 鋁 冇冠軍 Stanley said, the more repairs on your plane, the more you win Whatever. Make one for me. THANK YOU ! ! |
Page 1 of 1 | All times are UTC + 8 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |