RC Slope Soaring in Hong Kong
http://www.rcsail.com/forum/

Race-M & Aris repair
http://www.rcsail.com/forum/viewtopic.php?f=12&t=1676
Page 1 of 1

Author:  K.Y.Mak [ Mon Oct 12, 2009 12:27 pm ]
Post subject:  Race-M & Aris repair

星期日在 MOS 比賽時,才發現隻 Aris 有條定位pin 不見了
有誰可幫忙找到? 是鋁的6mm圓柱體 :!:

前晚修補隻 Race-M 出賽 MOS,
因太心急,近尾部推竿位的修補材料與推竿出現摩擦現像! 正在想辦法中 :!: :?: :idea:


我兩隻主戰機都同時有故障、慘 :!: :!: :!:

Author:  Ah Pong [ Mon Oct 12, 2009 1:08 pm ]
Post subject: 

Ah Mak,

I have 6mm steel that fit for the alignment pin. Tell me how long, and I can cut for you.

Do you have photo of the RaceM? May be I can tell you how to fix it.

BR, Pong

Author:  K.Y.Mak [ Mon Oct 12, 2009 3:16 pm ]
Post subject: 

Ah Pong wrote:
Ah Mak,

I have 6mm steel that fit for the alignment pin. Tell me how long, and I can cut for you.

Do you have photo of the RaceM? May be I can tell you how to fix it.

BR, Pong


Hi Ah Pong,

I think it's around 20mm long.
However, Steel is very hard !
Do you have the tool to make a rounded head on one end for easy insertion?
How about carbon rod ? :idea:

Author:  Ah Pong [ Mon Oct 12, 2009 7:53 pm ]
Post subject: 

The bad thing for using CF rod is, when it breaks, it would be so difficult to take the residual away.

Author:  CM Cheng [ Mon Oct 12, 2009 8:25 pm ]
Post subject: 

唔好攪,攪咗冇冠軍 :lol:

但如果冇冠軍都OK,我可以幫你車一條,你要 6061、7075 定五金鋪 cheap cheap 鋁 :lol:

Author:  K.Y.Mak [ Mon Oct 12, 2009 9:42 pm ]
Post subject: 

CM Cheng wrote:
唔好攪,攪咗冇冠軍 :lol:

但如果冇冠軍都OK,我可以幫你車一條,你要 6061、7075 定五金鋪 cheap cheap 鋁 :lol:


冇冠軍 :?:
Stanley said, the more repairs on your plane, the more you win :!:

Whatever.
Make one for me.

THANK YOU ! ! :D

Page 1 of 1 All times are UTC + 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/