RC Slope Soaring in Hong Kong
http://www.rcsail.com/forum/

F3F FlightSim problems. Kevin
http://www.rcsail.com/forum/viewtopic.php?f=12&t=1265		 Page 1 of 1
Author:  2212kevin [ Wed Jan 09, 2008 10:24 pm ]
Post subject:  F3F FlightSim problems. Kevin
To f3f Masters. Today i have been ShamShuiPo ApliuStreet WhaFai Electronic Ltd to buy flight sim parts,information from Angus thank you! from Mr亞麥 audio-interface 既資料, (Audio Input Jack to link with Electric Resistance100&10000unit, red cable for signal ppm & black cable for ground). here i have are problems,
1st* in WhaFai there are two electric resistance variety- Metal film and Carbon film with 1/4W 1/2W 1W or 2W... which one are the right E.Resistance & Watt(W) :wink:
2nd* for the cable, one end to link with PC Audio in & what can i do for the other end red/black cables to link with RC :wink:
Author:  Ah Pong [ Wed Jan 09, 2008 10:42 pm ]
Post subject: 
Hi Kevin,

The working voltage is very low. You might use either metal film or carbonate type at as low as 1/8 or 1/16 Watt. The resistor is only optional. My cable does not have such and works fine.

The connector to the transmitter depends on the type of transmitter of yours. FF9 uses square conector whilst 4 channel (older design) uses round shape connector.

Regards,
Author:  2212kevin [ Wed Jan 09, 2008 11:11 pm ]
Post subject:  To MrArPong.
Thanks a lot *DEMO speedy man* :wink: , i bought a DEMO(old style) too from ArKin, but you seem like have to quit F3F for a while, takecare your BB? anyway all the best & c u in the near future.
KevinC :wink:
Page 1 of 1 All times are UTC + 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/